25 Amp, 1500 Watt, 48 Volt Diversion Load Center

Designed for use with Diversion Controllers

Now with custom made Kanthal-A1 wire wound, high heat elements.

This Diversion Center Can be mounted on to a wall to provide heating as well as serve as a diversion (dummy) load.

These resistors have been custom made (here in Coleman Texas) specifically to perform as diversion (dummy) loads in solar/wind/hydro alternate energy systems. Unlike water heating elements, this unit does not need to be submerged in water or oil. It will operate in free air.

Each of the resistors we sell has been selected (or custom made) based on it's ability to dissipate a very specific amount of power (watts) with a very specific resistance value (ohms), at a very specific voltage. When used as recommended, they will not burn out, even under continuous use.

Please note. These resistors will become hot during normal use, please mount them away from heat sensitive objects and out of the reach of children.

The diversion load center consists of six resistors mounted directly onto two sheets of CNC cut, .063 aluminum (A left and right sheet). These two sheets form the electrical connection for the six resistors. Both sheets are mounted to a solid piece of ceramic board. Two terminals with aluminum nuts are provided for a solid connection to your wiring. The entire unit is enclosed in a Hoffman 12 x 16 x 4 enclosure with a vented cover